Effects of Anti-static chairs

Prevent troubles caused by electrostatic discharge(ESD)

Electro-static discharge (ESD) problems frequently occur in the environment where most advanced electron devices or instruments are handled.
Typical examples include damage or degradation of electron devices in the assembling line, failure of PC, computer and other electronics systems.
Most of the reasons why PC freeze are ESDs.
Human is the major element that causes ESD because it moves free.
To suppress electro-static charge caused by human body, anti-static wear, shoes, floor and wrist strap are used, but chairs are also important.

The ESD chairs which suppress static charge improve productivity...

Friction is the major source of static charge.
Though you use anti-static wear, shoes and floor, both human body and chair are charged by sitting up and down because of friction.
Some chairs may cause ESD soon after human left from it.
The EMI generated by this ESD triggers failure of neighboring instruments.
It is reported that this ESD occur in the gas cylinder.
All Gibo/Kodama chairs do not cause this problem.
Please use these chairs over the grounded conductive floor.

Introduction environment of Anti-static chairs

• Production and assemble line of the higher density electron devices
• Assemble and inspection line of electronic PC boards
• Assemble and inspection line of electronic equipment
• Office or labs where electronic equipment or PC is operated
• Warning environment against equipment failure or oxygen explosion such as hospital
• Environment to avoid the dust explosion

Introduction of Anti-static chairs

Research Laboratory /Laboratory	Research Laboratory /Laboratory	President's office /Executive suite	Cleanroom	Assembly lines

On the occasion of the use

Anti-static chairs discharge the electro-static charge of the human body by a safe speed, through the dissipative resistance, though static charge is generated by friction between clothes or body and back or seat, or by contact between human body and chair if it is located on the conductive floor. If floor is isolated from ground, it does not work. Please use on the conductive floor.